SG-type Inter-Connector consists of alternate layers of conductive and insulating silicone rubber and of rubber insulators with less stiffness, which are fitted on both sides. This type is suitable for small- or middle-sized displays. While SS type has translucent supportive solid rubber on the both sides, SG type has pink sponge rubber.

Outline Dimensions

Dimensions and Tolerances

Item	Unit	SG Type
Pitch (P)	mm	0.10±0.04, 0.18±0.05, 0.25±0.05
Length (L)	mm	2.0~20.0±0.15, 90.1~150.0±0.6, 200.1~270.0±1.0, 20.1~90.0±0.65%, 150.1~200.0±0.8, 270.1~300±1.5
Height (H)*	mm	1.0~5.0±0.1, 5.1~20.0+0.15/-0.1
Width (Standard) (W)	mm	1.2~2.3±0.1, 2.4~4.5±0.15
Width of Conductive   Layer (Z)	mm	0.4±0.05(standard), 0.8±0.05(secondary standard)

* HW/2
SS-N type, which has non-sticky sides is available on request.
Shin-Etsu Inter-Connector has been registered in European Community, TM No. 000299016, and in the United States of America, TM No. 2078941.

Basic Properties

Item	Component	Unit	SG Type
Specific Gravity	Insulator Conductor Edge insulation part		1.15 1.25 0.6
Shore Hardness A	Insulator Conductor Edge insulation part	ISO7619 (TYPE A)	65~73 63~67 17~23
Compression Set	*	%	12~18
Volume Resistivity	Insulator Conductor Edge insulation part	, cm	1×1014 3~6 1×1011
Dielectric Breakdown Voltage	Insulator Edge insulation part	kV/mm	23~27 2.0~2.5
Insulation Resistance (500V DC)	*	M	1×10³
Operating Temperature Range		°C	-25~85

* The test is carried out with Shin-Etsu's own method.

Compression Curves

Note